Rorke Data The Galaxy 65 Specifikace stáhnout pdf (Strana 29)

Chapter 2: Hardware Installation

2-1

Chapter 2

Hardware Installation

2.1 Introduction

This chapter gives detailed instructions on how to install the subsystem. When installing

the subsystem, it is necessary to mount the chassis into a rack or cabinet and to install

hard drives and drive trays. Installation into a rack or cabinet should occur before the

hard drives or drive trays are installed into the subsystem. Please confirm that you

received all of the components listed on the Unpacking List that came with the

subsystem before proceeding with the installation process.

CAUTION!

Please note that the installation instructions described in this chapter should be

carefully followed to prevent any difficulties and damages to your system.

2.2 Installation Pre-requisites

1. Static-free installation environment: The subsystem must be installed in a static-free

environment to minimize the possibility of electrostatic discharge (ESD) damage.

(See Section 2.3)

2. Component check: Before installing the subsystem, you should confirm that you

have received all of the required components by checking the package contents

against the Unpacking Checklist. If any items appear damaged, contact your vendor

for a replacement.

3. Hard drives: SATA-II hard drives have been pre-integrated into the Galaxy raid

trays. These drive trays must be installed before you can operate the Galaxy. If

replacement drives are needed, use this procedure to install them into the subsystem.

(See Section 2.9 for installation instructions)

4. Cabling:

(1). The subsystems come with no external cables for Fibre Channel connection to a

host computer. All host connection cables should be separately purchased.

Please see Chapter 4 for sample topologies and configuration options.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 99 100

Žádné komentáře

Rorke Data The Galaxy 65 Specifikace Strana 29